10-19-2023, 10:38 AM
The tablets I have are Boox Max 3 which have no frontlight (I think they were the last model without it).
Refresh mode is set to normal. I played with the modes when I first got them but normal works well so I've left it on that. I just had a look in the settings and it says that in normal mode it does a complete refresh every 20 operations and that it goes into X mode when scrolling. I almost always have MS set to single page which seems to make ghosting less likely. I just tried some vertical scrolling and you do get a bit more ghosting in the white areas than with single page but it's barely visible (ghosting is more obvious in dark areas but definitely not a problem). I thought I saw somewhere that it does a complete refresh with every page turn but messing around with it it looks more like it's doing a complete refresh each time I go to a new piece and not on page turns otherwise. I have a complete refresh set up on the navigation ball but I've never needed to use it.
I don't do a lot of annotating but the writing speed is close to instant. I think Mike mentioned that there are a couple of ways of implementing stylus writing with these tablets and that one of them is instant and the other isn't. I have a feeling that 'stylus mode' uses the instant one and that that's what I'm using. I just gave it a quick try and deselecting stylus mode did make the writing response slower.
Refresh mode is set to normal. I played with the modes when I first got them but normal works well so I've left it on that. I just had a look in the settings and it says that in normal mode it does a complete refresh every 20 operations and that it goes into X mode when scrolling. I almost always have MS set to single page which seems to make ghosting less likely. I just tried some vertical scrolling and you do get a bit more ghosting in the white areas than with single page but it's barely visible (ghosting is more obvious in dark areas but definitely not a problem). I thought I saw somewhere that it does a complete refresh with every page turn but messing around with it it looks more like it's doing a complete refresh each time I go to a new piece and not on page turns otherwise. I have a complete refresh set up on the navigation ball but I've never needed to use it.
I don't do a lot of annotating but the writing speed is close to instant. I think Mike mentioned that there are a couple of ways of implementing stylus writing with these tablets and that one of them is instant and the other isn't. I have a feeling that 'stylus mode' uses the instant one and that that's what I'm using. I just gave it a quick try and deselecting stylus mode did make the writing response slower.