[juergen_montage]

Hello Mike.

Many thanks for your help and sorry for my late reply. Not enough time at the moment....,

I´m still fighting with the Montage, no progress until now.  So I try to summarize my situation:

At the Montage I set at the Utility-Page "Midi I/O"
- MIDI IN/OUT: USB
- Local Control ON
- MIDI Sync: MIDI
- Receive / Transmit: ON

At Advanced:
- Zone Master: OFF
- MIDI I/O Mode: Single
- MIDI I/O Channel: 1
- Device Number 1
- Bank Select / Pgm Change: ON

My Samsung Tablet is connected via USB to the Montage.
At the "MIDI-Befehl bearbeiten" I´ve tested (and played around) with all settings I found and understand.
- Befehlstyp: Patch Select
- Kanal: 1
- Eingangsport: Alle (Yamaha Corporation MONTAGE[0], [1], [2]) - I also tried the ports separate.
- Ausgangsport: Alles
- Befehl: MSB / LSB / Wert(Patch)

The MIDI Settings inside MobileSheetsPro are:
- MIDI Receive chanel: 16
- MIDI Send chanel 10
- "Mehrere MIDI-Kanäle erlauben" (Allow more MIDI chanels)
- MIDI-Gerät / MIDI-Device: Generisch/Generic
- MIDI-Bibliothek: Google / Type: USB (Dialog Shows the "Yamaha Corporatio MONTAGE[0-3] at MIDI In and Outports

I´ve choose a song to implement the MIDI-Command and try to test via Button "MIDI-BEFEHL TESTEN" (Sorry, German :-))
- Montage shows at the propertiy page at a Performance the Bank / Bank Select ang Program Change No. (For example MSB64, LSB, 32, Prog. Change 019). Tried this adress in MobileSheets - w/o succes.
- Followed your Info MSB63 / LSB xx / Prog Change xx out of your post. Even for User or Presets. - w/o succes.

So currently I´m out of any ideas. Normally I understand such simpe MIDI Settings and Program Change stuff, but at the Montage I´m at the end of my ideas.

Best Regards from Germany,
Juergen